u-boot-brain/arch/powerpc/cpu/mpc83xx/Makefile
Heiko Schocher 5990b05951 powerpc, qe: add DTS support for parallel I/O ports
add DM support for parallel I/O ports on QUICC Engine Block

Signed-off-by: Heiko Schocher <hs@denx.de>
Patch-cc: Mario Six <mario.six@gdsys.cc>
Patch-cc: Qiang Zhao <qiang.zhao@nxp.com>
Patch-cc: Holger Brunck <holger.brunck@hitachi-powergrids.com>

Series-changes: 2
- remove RFC
- fixed Codingstyle errors, therefore new patch
  powerpc, mpc83xx: fix codingstyle issues for qe_io.c
- moved DM part to drivers/pinctrl

Commit-notes:
Open questions / discussion:

- I let the old none DM based implementation in code
  so boards should work with old implementation.

  This should be removed if all boards are converted to
  DM/DTS.

- Unfortunately linux DTS does not use "pinctrl-"
  properties, instead "pio-handle" properties.

  Even worser old U-Boot code initializes all pins
  defined in "const qe_iop_conf_t qe_iop_conf_tab[]"
  table in board code. As linux does the same I decided
  to also scan through all subnodes containing "pio-map"
  property and initialize them too.

  The proper solution would be to check for "pio-handle"
  when a device is probed.

END
2020-09-17 06:09:53 +02:00

46 lines
753 B
Makefile

# SPDX-License-Identifier: GPL-2.0+
#
# (C) Copyright 2006
# Wolfgang Denk, DENX Software Engineering, wd@denx.de.
#
# Copyright 2004 Freescale Semiconductor, Inc.
MINIMAL=
ifdef CONFIG_SPL_BUILD
ifdef CONFIG_SPL_INIT_MINIMAL
MINIMAL=y
endif
endif
extra-y = start.o
ifdef MINIMAL
obj-y += spl_minimal.o
else
obj-y += traps.o
obj-y += cpu.o
obj-y += cpu_init.o
obj-y += speed.o
obj-y += interrupts.o
obj-y += ecc.o
ifndef CONFIG_PINCTRL
obj-$(CONFIG_QE) += qe_io.o
endif
obj-$(CONFIG_FSL_SERDES) += serdes.o
ifndef CONFIG_ARCH_MPC8308
obj-$(CONFIG_PCI) += pci.o
endif
obj-$(CONFIG_PCIE) += pcie.o
obj-$(CONFIG_OF_LIBFDT) += fdt.o
ifndef CONFIG_SYS_FSL_DDRC_GEN2
obj-y += spd_sdram.o
endif
obj-$(CONFIG_SYS_FSL_DDR2) += law.o
endif # not minimal