mirror of
https://github.com/brain-hackers/u-boot-brain
synced 2024-08-12 21:23:57 +09:00
d3384bf77e
For all the UniPhier SoCs so far, the reset signal of the NAND core is automatically deasserted after the PLL gets stabled. (The bit 2 of SC_RSTCTRL is default to one.) This causes a fatal problem on the NAND controller of PH1-LD4. For that SoC, the NAND I/O pins are not set up yet at the power-on reset except the NAND boot mode. As a result, the NAND controller begins automatic device scanning with wrong I/O pins and finally hangs up. Actually, U-Boot dies after printing "NAND:" on the console unless the boot mode latch detected the NAND boot mode. To work around this problem, reset the NAND core in SPL for non-NAND boot modes. If CONFIG_NAND_DENALI is enabled, the reset signal is deasserted again in U-Boot proper. At this time, I/O pins have been correctly set up, the device scanning should succeed. Signed-off-by: Masahiro Yamada <yamada.m@jp.panasonic.com> |
||
|---|---|---|
| .. | ||
| arc | ||
| arm | ||
| avr32 | ||
| blackfin | ||
| m68k | ||
| microblaze | ||
| mips | ||
| nds32 | ||
| nios2 | ||
| openrisc | ||
| powerpc | ||
| sandbox | ||
| sh | ||
| sparc | ||
| x86 | ||
| .gitignore | ||
| Kconfig | ||