u-boot-brain/board/freescale
Peng Fan 361b715bbf imx: mx6qpsabreauto: Add MX6QP SABREAUTO CPU3 board support
1. Add DDR script for mx6qpsabreauto board.
2. On CPU3 board, enet RGMII tx clock is from internal PLL. Set the GPR5[9]
   and init the enet pll output to 125Mhz.
3. On CPU3 board, SW1ABC=VDDSOC_IN, SW2=VDDARM_IN.

Build target: mx6qpsabreauto_config

Boot Log:
U-Boot 2015.07-rc2-00071-gfd985ff (Jun 29 2015 - 22:10:55 +0800)

CPU:   Freescale i.MX6QP rev1.0 996 MHz (running at 792 MHz)
CPU:   Automotive temperature grade (-40C to 125C) at 34C
Reset cause: POR
Board: MX6Q-Sabreauto revA
I2C:   ready
DRAM:  2 GiB
PMIC:  PFUZE100 ID=0x10
Flash: 32 MiB
NAND:  0 MiB
MMC:   FSL_SDHC: 0
*** Warning - bad CRC, using default environment

No panel detected: default to HDMI
Display: HDMI (1024x768)
In:    serial
Out:   serial
Err:   serial
Net:   FEC [PRIME]
Hit any key to stop autoboot:  0

Note:
In this patch, we still add a new config mx6qpsabreauto_config,
since SPL is not supported now, and IMX_CONFIG is needed at
build time, so add this config. Future, when SPL is converted,
this config can be removed.

Signed-off-by: Peng Fan <Peng.Fan@freescale.com>
Signed-off-by: Robin Gong <b38343@freescale.com>
Signed-off-by: Ye.Li <B37916@freescale.com>
Reviewed-by: Fabio Estevam <fabio.estevam@freescale.com>
2015-08-02 10:47:52 +02:00
..
b4860qds B4860QDS: Enable enet port as per fsl_b4860_serdes2 string in hwconfig 2014-12-05 08:06:14 -08:00
bsc9131rdb fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
bsc9132qds driver/ifc: Add 64KB page support 2015-04-23 16:46:50 -07:00
c29xpcie driver/ifc: Add 64KB page support 2015-04-23 16:46:50 -07:00
common pmic: pfuze100 fix typo 2015-05-19 15:13:38 +02:00
corenet_ds powerpc/mpc85xx: SECURE BOOT- Add secure boot target for P5040DS 2015-01-16 09:27:15 -08:00
ls1021aqds pci/layerscape: remove unnecessary pcie_layerscape.h 2015-04-21 10:19:19 -07:00
ls1021atwr arm/ls1021a: Remove ccsr_ddr from immap_ls102xa.h 2015-05-20 10:34:09 -07:00
ls2085a fsl-lsch3: Introduce place for common early SoC init 2015-04-23 08:55:56 -07:00
ls2085aqds armv8/ls2085aqds: NAND boot support 2015-04-23 16:46:50 -07:00
ls2085ardb armv8/ls2085ardb: Enable NAND SPL support 2015-04-23 16:46:51 -07:00
m547xevb m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m548xevb m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m5208evbe m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m5235evb m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m5249evb m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m5253demo m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m5253evbe m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m5272c3 m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m5275evb m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m5282evb m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m5329evb m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m5373evb m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m52277evb m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m53017evb m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m54418twr m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m54451evb m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
m54455evb m68k: add architecture-specific u-boot.lds 2015-04-23 14:56:07 -04:00
mpc832xemds fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc837xemds fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc837xerdb mpc837xerdb: "fix Calling __hwconfig without a buffer" warning 2015-03-02 15:11:36 -05:00
mpc5121ads fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8308rdb fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8313erdb fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8315erdb fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8323erdb fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8349emds fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8349itx fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8536ds fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8540ads fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8541cds MAINTAINERS: comment out invalid maintainers 2014-09-24 18:30:28 -04:00
mpc8544ds fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8548cds MAINTAINERS: comment out blank M: field 2014-09-24 18:30:28 -04:00
mpc8555cds MAINTAINERS: comment out invalid maintainers 2014-09-24 18:30:28 -04:00
mpc8560ads fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8568mds fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8569mds fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8572ds fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8610hpcd fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
mpc8641hpcn fdt: Try to use fdt_address_cells()/fdt_size_cells() 2014-11-21 04:43:18 +01:00
mx6qarm2 imx:mx6qarm2 add board level support for usb 2014-12-19 15:32:13 +01:00
mx6qsabreauto imx: mx6qpsabreauto: Add MX6QP SABREAUTO CPU3 board support 2015-08-02 10:47:52 +02:00
mx6sabresd imx: mx6sabresd/sabreauto runtime setting fdt_file 2015-08-02 10:47:05 +02:00
mx6slevk mx6slevk: Provide a proper pad configuration for OTG1_ID pin 2015-03-02 11:55:26 +01:00
mx6sxsabresd mx6sxsabresd: Use 'int' for return values 2015-07-26 12:12:04 +02:00
mx23evk kconfig: arm: introduce symbol for ARM CPUs 2014-10-29 09:02:09 -04:00
mx25pdk mx25pdk: Turn on the LCD supply 2015-03-02 09:57:05 +01:00
mx28evk mx28evk: README: Revision C is also supported 2014-11-12 09:05:57 +01:00
mx31ads kconfig: arm: introduce symbol for ARM CPUs 2014-10-29 09:02:09 -04:00
mx31pdk kconfig: arm: introduce symbol for ARM CPUs 2014-10-29 09:02:09 -04:00
mx35pdk kconfig: arm: introduce symbol for ARM CPUs 2014-10-29 09:02:09 -04:00
mx51evk mx51evk: Fix MX51EVK_USB_CLK_EN_B definition 2014-12-19 15:32:14 +01:00
mx53ard mx53ard: Fix error handling in board_mmc_init() 2014-11-21 16:47:55 +01:00
mx53evk mx53evk: Fix error handling in board_mmc_init() 2014-11-21 16:47:55 +01:00
mx53loco mx53loco: Disable printing cpuinfo 2015-04-08 10:45:50 +02:00
mx53smd mx53smd: Fix error handling in board_mmc_init() 2014-11-21 16:47:55 +01:00
p1_p2_rdb_pc fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
p1_twr fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
p1010rdb driver/ifc: Add 64KB page support 2015-04-23 16:46:50 -07:00
p1022ds fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
p1023rdb fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
p2041rdb fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
qemu-ppce500 fdt: Allow ft_board_setup() to report failure 2014-11-21 04:43:15 +01:00
t4qds powerpc/t4240qds: Update RCW, defconfig and maintainer 2015-05-04 09:26:01 -07:00
t4rdb powerpc/t4rdb: Add SD boot support for T4240RDB board 2015-05-04 09:24:04 -07:00
t102xqds board/t102x: use fdt_setprop_string instead of fdt_setprop 2015-05-04 09:24:50 -07:00
t102xrdb board/t102x: use fdt_setprop_string instead of fdt_setprop 2015-05-04 09:24:50 -07:00
t104xrdb mpc85xx/t104xrdb : remove raw timing parameter 2015-03-05 12:03:22 -08:00
t208xqds powerpc/t2080: updating rcw for silicon v1.1 2014-12-05 08:06:14 -08:00
t208xrdb t2080rdb/rcw: update ddr frequency from 1600MT/s to 1867MT/s 2015-05-04 09:25:53 -07:00
t1040qds board/T1040qds: Add VSC9953 support for T1040qds board 2015-01-21 09:23:36 -06:00
vf610twr ARM: vf610: Enable external 32KHz oscillator 2015-04-23 14:56:08 -04:00