nand: davinci: remove dead code for dm644x

The support for DaVinci DM* SoCs has been dropped. The code that used
to be relevant to dm644x is no longer needed. Remove it.

Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
This commit is contained in:
Bartosz Golaszewski 2019-04-29 18:37:10 +02:00 committed by Tom Rini
parent 0c56542592
commit a7fc3d7c68

View File

@ -730,43 +730,6 @@ static int nand_davinci_dev_ready(struct mtd_info *mtd)
return __raw_readl(&davinci_emif_regs->nandfsr) & 0x1;
}
static void nand_flash_init(void)
{
/* This is for DM6446 EVM and *very* similar. DO NOT GROW THIS!
* Instead, have your board_init() set EMIF timings, based on its
* knowledge of the clocks and what devices are hooked up ... and
* don't even do that unless no UBL handled it.
*/
#ifdef CONFIG_SOC_DM644X
u_int32_t acfg1 = 0x3ffffffc;
/*------------------------------------------------------------------*
* NAND FLASH CHIP TIMEOUT @ 459 MHz *
* *
* AEMIF.CLK freq = PLL1/6 = 459/6 = 76.5 MHz *
* AEMIF.CLK period = 1/76.5 MHz = 13.1 ns *
* *
*------------------------------------------------------------------*/
acfg1 = 0
| (0 << 31) /* selectStrobe */
| (0 << 30) /* extWait */
| (1 << 26) /* writeSetup 10 ns */
| (3 << 20) /* writeStrobe 40 ns */
| (1 << 17) /* writeHold 10 ns */
| (1 << 13) /* readSetup 10 ns */
| (5 << 7) /* readStrobe 60 ns */
| (1 << 4) /* readHold 10 ns */
| (3 << 2) /* turnAround ?? ns */
| (0 << 0) /* asyncSize 8-bit bus */
;
__raw_writel(acfg1, &davinci_emif_regs->ab1cr); /* CS2 */
/* NAND flash on CS2 */
__raw_writel(0x00000101, &davinci_emif_regs->nandfcr);
#endif
}
void davinci_nand_init(struct nand_chip *nand)
{
#if defined CONFIG_KEYSTONE_RBL_NAND
@ -820,8 +783,6 @@ void davinci_nand_init(struct nand_chip *nand)
nand->write_buf = nand_davinci_write_buf;
nand->dev_ready = nand_davinci_dev_ready;
nand_flash_init();
}
int board_nand_init(struct nand_chip *chip) __attribute__((weak));