u-boot-brain/drivers/mtd/spi/sf_probe.c

174 lines
3.7 KiB
C
Raw Normal View History

// SPDX-License-Identifier: GPL-2.0+
/*
* SPI flash probing
*
* Copyright (C) 2008 Atmel Corporation
* Copyright (C) 2010 Reinhard Meyer, EMK Elektronik
* Copyright (C) 2013 Jagannadha Sutradharudu Teki, Xilinx Inc.
*/
#include <common.h>
#include <dm.h>
#include <errno.h>
#include <log.h>
#include <malloc.h>
#include <spi.h>
#include <spi_flash.h>
#include "sf_internal.h"
/**
* spi_flash_probe_slave() - Probe for a SPI flash device on a bus
*
* @flashp: Pointer to place to put flash info, which may be NULL if the
* space should be allocated
*/
static int spi_flash_probe_slave(struct spi_flash *flash)
{
struct spi_slave *spi = flash->spi;
int ret;
/* Setup spi_slave */
if (!spi) {
printf("SF: Failed to set up slave\n");
return -ENODEV;
}
/* Claim spi bus */
ret = spi_claim_bus(spi);
if (ret) {
debug("SF: Failed to claim SPI bus: %d\n", ret);
return ret;
}
ret = spi_nor_scan(flash);
if (ret)
goto err_read_id;
if (CONFIG_IS_ENABLED(SPI_FLASH_MTD))
ret = spi_flash_mtd_register(flash);
err_read_id:
spi_release_bus(spi);
return ret;
}
spi: Convert CONFIG_DM_SPI* to CONFIG_$(SPL_TPL_)DM_SPI* This change allows more fine tuning of driver model based SPI support in SPL and TPL. It is now possible to explicitly enable/disable the DM_SPI support in SPL and TPL via Kconfig option. Before this change it was necessary to use: /* SPI Flash Configs */ #if defined(CONFIG_SPL_BUILD) #undef CONFIG_DM_SPI #undef CONFIG_DM_SPI_FLASH #undef CONFIG_SPI_FLASH_MTD #endif in the ./include/configs/<board>.h, which is error prone and shall be avoided when we strive to switch to Kconfig. The goal of this patch: Provide distinction for DM_SPI support in both U-Boot proper and SPL (TPL). Valid use case is when U-Boot proper wants to use DM_SPI, but SPL must still support non DM driver. Another use case is the conversion of non DM/DTS SPI driver to support DM/DTS. When such driver needs to work in both SPL and U-Boot proper, the distinction is needed in Kconfig (also if SPL version of the driver supports OF_PLATDATA). In the end of the day one would have to support following use cases (in single driver file - e.g. mxs_spi.c): - U-Boot proper driver supporting DT/DTS - U-Boot proper driver without DT/DTS support (deprecated) - SPL driver without DT/DTS support - SPL (and TPL) driver with DT/DTS (when the SoC has enough resources to run full blown DT/DTS) - SPL driver with DT/DTS and SPL_OF_PLATDATA (when one have constrained environment with no fitImage and OF_LIBFDT support). Some boards do require SPI support (with DM) in SPL (TPL) and some only have DM_SPI{_FLASH} defined to allow compiling SPL. This patch converts #ifdef CONFIG_DM_SPI* to #if CONFIG_IS_ENABLED(DM_SPI) and provides corresponding defines in Kconfig. Signed-off-by: Lukasz Majewski <lukma@denx.de> Tested-by: Adam Ford <aford173@gmail.com> #da850-evm Signed-off-by: Hou Zhiqiang <Zhiqiang.Hou@nxp.com> [trini: Fixup a few platforms] Signed-off-by: Tom Rini <trini@konsulko.com>
2020-06-05 00:11:53 +09:00
#if !CONFIG_IS_ENABLED(DM_SPI_FLASH)
struct spi_flash *spi_flash_probe(unsigned int busnum, unsigned int cs,
unsigned int max_hz, unsigned int spi_mode)
{
struct spi_slave *bus;
struct spi_flash *flash;
bus = spi_setup_slave(busnum, cs, max_hz, spi_mode);
if (!bus)
return NULL;
/* Allocate space if needed (not used by sf-uclass */
flash = calloc(1, sizeof(*flash));
if (!flash) {
debug("SF: Failed to allocate spi_flash\n");
return NULL;
}
flash->spi = bus;
if (spi_flash_probe_slave(flash)) {
spi_free_slave(bus);
free(flash);
return NULL;
}
return flash;
}
void spi_flash_free(struct spi_flash *flash)
{
if (CONFIG_IS_ENABLED(SPI_FLASH_MTD))
spi_flash_mtd_unregister();
spi_free_slave(flash->spi);
free(flash);
}
#else /* defined CONFIG_DM_SPI_FLASH */
static int spi_flash_std_read(struct udevice *dev, u32 offset, size_t len,
void *buf)
{
struct spi_flash *flash = dev_get_uclass_priv(dev);
struct mtd_info *mtd = &flash->mtd;
size_t retlen;
return log_ret(mtd->_read(mtd, offset, len, &retlen, buf));
}
static int spi_flash_std_write(struct udevice *dev, u32 offset, size_t len,
const void *buf)
{
struct spi_flash *flash = dev_get_uclass_priv(dev);
struct mtd_info *mtd = &flash->mtd;
size_t retlen;
return mtd->_write(mtd, offset, len, &retlen, buf);
}
static int spi_flash_std_erase(struct udevice *dev, u32 offset, size_t len)
{
struct spi_flash *flash = dev_get_uclass_priv(dev);
struct mtd_info *mtd = &flash->mtd;
struct erase_info instr;
if (offset % mtd->erasesize || len % mtd->erasesize) {
printf("SF: Erase offset/length not multiple of erase size\n");
return -EINVAL;
}
memset(&instr, 0, sizeof(instr));
instr.addr = offset;
instr.len = len;
return mtd->_erase(mtd, &instr);
}
int spi_flash_std_probe(struct udevice *dev)
{
struct spi_slave *slave = dev_get_parent_priv(dev);
struct spi_flash *flash;
flash = dev_get_uclass_priv(dev);
flash->dev = dev;
flash->spi = slave;
return spi_flash_probe_slave(flash);
}
static int spi_flash_std_remove(struct udevice *dev)
{
if (CONFIG_IS_ENABLED(SPI_FLASH_MTD))
spi_flash_mtd_unregister();
return 0;
}
static const struct dm_spi_flash_ops spi_flash_std_ops = {
.read = spi_flash_std_read,
.write = spi_flash_std_write,
.erase = spi_flash_std_erase,
};
static const struct udevice_id spi_flash_std_ids[] = {
{ .compatible = "jedec,spi-nor" },
{ }
};
U_BOOT_DRIVER(spi_flash_std) = {
.name = "spi_flash_std",
.id = UCLASS_SPI_FLASH,
.of_match = spi_flash_std_ids,
.probe = spi_flash_std_probe,
.remove = spi_flash_std_remove,
.priv_auto_alloc_size = sizeof(struct spi_flash),
.ops = &spi_flash_std_ops,
};
#endif /* CONFIG_DM_SPI_FLASH */