mirror of
https://github.com/brain-hackers/u-boot-brain
synced 2024-09-11 23:33:26 +09:00
![]() This patch adds support for parallel NOR device (S29GL512S10) present on J6-EVM. The Flash device is connected to GPMC controller on chip-select[0] and accessed as memory-mapped device. It has data-witdh=x16, capacity-64MBytes(512Mbits) and is CFI compatible. As multiple devices are share GPMC pins on this board, so following board settings are required to detect NOR device: SW5.1 (NAND_BOOTn) = OFF (logic-1) SW5.2 (NOR_BOOTn) = ON (logic-0) /* Active-low */ SW5.3 (eMMC_BOOTn) = OFF (logic-1) SW5.4 (QSPI_BOOTn) = OFF (logic-1) And also set appropriate SYSBOOT configurations: SW3.1 (SYSBOOT[ 8])= ON (logic-1) /* selects SYS_CLK1 speed */ SW3.2 (SYSBOOT[ 9])= OFF (logic-0) /* selects SYS_CLK1 speed */ SW3.3 (SYSBOOT[10])= ON (logic-1) /* wait-pin monitoring = enabled */ SW3.4 (SYSBOOT[11])= OFF (logic-0) /* device type: Non Muxed */ SW3.5 (SYSBOOT[12])= OFF (logic-0) /* device type: Non Muxed */ SW3.6 (SYSBOOT[13])= ON (logic-1) /* device bus-width: 1(x16) */ SW3.7 (SYSBOOT[14])= OFF (logic-0) /* reserved */ SW3.8 (SYSBOOT[15])= ON (logic-1) /* reserved */ Also, following changes are required to enable NOR Flash support in dra7xx_evm board profile: |
||
---|---|---|
.. | ||
evm.c | ||
Kconfig | ||
MAINTAINERS | ||
Makefile | ||
mux_data.h | ||
README |
Summary ======= This document covers various features of the 'dra7xx_evm' build and some related uses. eMMC boot partition use ======================= It is possible, depending on SYSBOOT configuration to boot from the eMMC boot partitions using (name depending on documentation referenced) Alternative Boot operation mode or Boot Sequence Option 1/2. In this example we load MLO and u-boot.img from the build into DDR and then use 'mmc bootbus' to set the required rate (see TRM) and 'mmc partconfig' to set boot0 as the boot device. U-Boot # setenv autoload no U-Boot # usb start U-Boot # dhcp U-Boot # mmc dev 1 1 U-Boot # tftp ${loadaddr} dra7xx/MLO U-Boot # mmc write ${loadaddr} 0 100 U-Boot # tftp ${loadaddr} dra7xx/u-boot.img U-Boot # mmc write ${loadaddr} 300 400 U-Boot # mmc bootbus 1 2 0 2 U-Boot # mmc partconf 1 1 1 0 U-Boot # mmc rst-function 1 1