mirror of
https://github.com/brain-hackers/u-boot-brain
synced 2024-08-19 00:18:51 +09:00
![]() If board is booted with transitions happening on DCAN1 pins then the following warning is seen in the kernel at boot when the hwmod layer initializes. "omap_hwmod: dcan1: _wait_target_disable failed" This is because DCAN1 module's SWAKEUP mechanism is broken and it fails to correctly turn OFF if it sees a transition on the DCAN1 pins. Suggested workaround is to keep DCAN1 pins in safe mode while enabling/disabling DCAN1 module. The hwmod layer enables and disables all modules at boot and we have no opportunity to put the DCAN1 pins in safe mode at that point. DCAN1 is not used by u-boot so it doesn't matter to it if these pins are in safe mode. The kernel driver correctly configures the right mode when DCAN1 is active. Signed-off-by: Roger Quadros <rogerq@ti.com> |
||
---|---|---|
.. | ||
evm.c | ||
Kconfig | ||
MAINTAINERS | ||
Makefile | ||
mux_data.h | ||
README |
Summary ======= This document covers various features of the 'dra7xx_evm' build and some related uses. eMMC boot partition use ======================= It is possible, depending on SYSBOOT configuration to boot from the eMMC boot partitions using (name depending on documentation referenced) Alternative Boot operation mode or Boot Sequence Option 1/2. In this example we load MLO and u-boot.img from the build into DDR and then use 'mmc bootbus' to set the required rate (see TRM) and 'mmc partconfig' to set boot0 as the boot device. U-Boot # setenv autoload no U-Boot # usb start U-Boot # dhcp U-Boot # mmc dev 1 1 U-Boot # tftp ${loadaddr} dra7xx/MLO U-Boot # mmc write ${loadaddr} 0 100 U-Boot # tftp ${loadaddr} dra7xx/u-boot.img U-Boot # mmc write ${loadaddr} 300 400 U-Boot # mmc bootbus 1 2 0 2 U-Boot # mmc partconf 1 1 1 0 U-Boot # mmc rst-function 1 1