u-boot-brain/arch/arm/dts/exynos4210-trats.dts
Akshay Saraswat f6ae1ca058 S5P: Exynos: Add GPIO pin numbering and rename definitions
This patch includes following changes :
* Adds gpio pin numbering support for EXYNOS SOCs.
  To have consistent 0..n-1 GPIO numbering the banks are divided
  into different parts where ever they have holes in them.

* Rename GPIO definitions from GPIO_... to S5P_GPIO_...
  These changes were done to enable cmd_gpio for EXYNOS and
  cmd_gpio has GPIO_INPUT same as s5p_gpio driver and hence
  getting a error during compilation.

* Adds support for name to gpio conversion in s5p_gpio to enable
  gpio command EXYNOS SoCs. Function has been added to asm/gpio.h
  to decode the input gpio name to gpio number.
  Example: SMDK5420 # gpio set gpa00

Signed-off-by: Leela Krishna Amudala <l.krishna@samsung.com>
Signed-off-by: Rajeshwari Shinde <rajeshwari.s@samsung.com>
Signed-off-by: Akshay Saraswat <akshay.s@samsung.com>
Acked-by: Przemyslaw Marczak <p.marczak@samsung.com>
Signed-off-by: Minkyu Kang <mk7.kang@samsung.com>
2014-05-13 15:20:38 +09:00

121 lines
2.6 KiB
Plaintext

/*
* Samsung's Exynos4210 based Trats board device tree source
*
* Copyright (c) 2014 Samsung Electronics Co., Ltd.
* http://www.samsung.com
*
* SPDX-License-Identifier: GPL-2.0+
*/
/dts-v1/;
/include/ "exynos4.dtsi"
/ {
model = "Samsung Trats based on Exynos4210";
compatible = "samsung,trats", "samsung,exynos4210";
config {
samsung,dsim-device-name = "s6e8ax0";
};
aliases {
i2c0 = "/i2c@13860000";
i2c1 = "/i2c@13870000";
i2c2 = "/i2c@13880000";
i2c3 = "/i2c@13890000";
i2c4 = "/i2c@138a0000";
i2c5 = "/i2c@138b0000";
i2c6 = "/i2c@138c0000";
i2c7 = "/i2c@138d0000";
serial0 = "/serial@13800000";
console = "/serial@13820000";
mmc0 = "sdhci@12510000";
mmc2 = "sdhci@12530000";
};
fimd@11c00000 {
compatible = "samsung,exynos-fimd";
reg = <0x11c00000 0xa4>;
samsung,vl-freq = <60>;
samsung,vl-col = <720>;
samsung,vl-row = <1280>;
samsung,vl-width = <720>;
samsung,vl-height = <1280>;
samsung,vl-clkp = <0>;
samsung,vl-oep = <0>;
samsung,vl-hsp = <1>;
samsung,vl-vsp = <1>;
samsung,vl-dp = <1>;
samsung,vl-bpix = <4>;
samsung,vl-hspw = <5>;
samsung,vl-hbpd = <10>;
samsung,vl-hfpd = <10>;
samsung,vl-vspw = <2>;
samsung,vl-vbpd = <1>;
samsung,vl-vfpd = <13>;
samsung,vl-cmd-allow-len = <0xf>;
samsung,winid = <3>;
samsung,power-on-delay = <30>;
samsung,interface-mode = <1>;
samsung,mipi-enabled = <1>;
samsung,dp-enabled;
samsung,dual-lcd-enabled;
samsung,logo-on = <1>;
samsung,resolution = <0>;
samsung,rgb-mode = <0>;
};
mipidsi@11c80000 {
compatible = "samsung,exynos-mipi-dsi";
reg = <0x11c80000 0x5c>;
samsung,dsim-config-e-interface = <1>;
samsung,dsim-config-e-virtual-ch = <0>;
samsung,dsim-config-e-pixel-format = <7>;
samsung,dsim-config-e-burst-mode = <1>;
samsung,dsim-config-e-no-data-lane = <3>;
samsung,dsim-config-e-byte-clk = <0>;
samsung,dsim-config-hfp = <1>;
samsung,dsim-config-p = <3>;
samsung,dsim-config-m = <120>;
samsung,dsim-config-s = <1>;
samsung,dsim-config-pll-stable-time = <500>;
samsung,dsim-config-esc-clk = <20000000>;
samsung,dsim-config-stop-holding-cnt = <0x7ff>;
samsung,dsim-config-bta-timeout = <0xff>;
samsung,dsim-config-rx-timeout = <0xffff>;
samsung,dsim-device-id = <0xffffffff>;
samsung,dsim-device-bus-id = <0>;
samsung,dsim-device-reverse-panel = <1>;
};
sdhci@12510000 {
samsung,bus-width = <8>;
samsung,timing = <1 3 3>;
pwr-gpios = <&gpio 0xA2 0>;
};
sdhci@12520000 {
status = "disabled";
};
sdhci@12530000 {
samsung,bus-width = <4>;
samsung,timing = <1 2 3>;
cd-gpios = <&gpio 0x39C 0>;
};
sdhci@12540000 {
status = "disabled";
};
};