mirror of
https://github.com/brain-hackers/u-boot-brain
synced 2024-08-22 18:09:03 +09:00
![]() Move this out of the common header and include it only where needed. In a number of cases this requires adding "struct udevice;" to avoid adding another large header or in other cases replacing / adding missing header files that had been pulled in, very indirectly. Finally, we have a few cases where we did not need to include <asm/global_data.h> at all, so remove that include. Signed-off-by: Simon Glass <sjg@chromium.org> Signed-off-by: Tom Rini <trini@konsulko.com> |
||
---|---|---|
.. | ||
Kconfig | ||
MAINTAINERS | ||
Makefile | ||
mys_6ulx.c | ||
README | ||
spl.c |
How to use U-Boot on MYiR MYS-6ULX Single Board Computer -------------------------------------------------------- - Configure and build U-Boot for MYS-6ULX iMX6ULL: $ make mrproper $ make myir_mys_6ulx_defconfig $ make This will generate SPL and u-boot-dtb.img images. Boot from MMC/SD: - The SPL and u-boot-dtb.img images need to be flashed into the micro SD card: $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync $ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync - Boot mode settings: Boot switch position: SW1 -> 0 SW2 -> 1 SW3 -> 0 SW4 -> 1 Boot from NAND: - Boot the board using SD/MMC or Serial download and load the SPL into memory either from SD/MMC or TFTP. Default MTD layout is 512k(spl),1m(uboot),1m(uboot-dup),-(ubi) Flash SPL to NAND from SD/MMC, $ ext4load mmc 0:2 $loadaddr SPL $ nand erase.part spl $ nandbcb init $loadaddr 0x0 $filesize Flash u-boot proper to NAND from SD/MMC, $ ext4load mmc 0:2 $loadaddr u-boot-dtb.img $ nand erase.part uboot $ nand write $loadaddr uboot $filesize - Boot mode settings: Boot switch position: SW1 -> 1 SW2 -> 0 SW3 -> 0 SW4 -> 1 - Connect the Serial cable to UART0 and the PC for the console. - Reset the board using and U-Boot should boot from NAND.