mirror of
https://github.com/brain-hackers/u-boot-brain
synced 2024-08-22 01:48:52 +09:00
![]() Converted to use fsl_esdhc_imx for i.MX platforms. Signed-off-by: Yangbo Lu <yangbo.lu@nxp.com> Tested-by: Steffen Dirkwinkel <s.dirkwinkel@beckhoff.com> Reviewed-by: Peng Fan <peng.fan@nxp.com> Reviewed-by: Lukasz Majewski <lukma@denx.de> Reviewed-by: Martyn Welch <martyn.welch@collabora.com> Acked-by: Jason Liu <Jason.hui.liu@nxp.com> |
||
---|---|---|
.. | ||
dart_6ul.c | ||
Kconfig | ||
MAINTAINERS | ||
Makefile | ||
README | ||
spl.c |
How to use U-Boot on variscite DART-6UL Evaluation Kit ------------------------------------------------------ - Configure and build U-Boot for DART-6UL iMX6ULL: $ make mrproper $ make variscite_dart6ul_defconfig $ make This will generate SPL and u-boot-dtb.img images. Boot from MMC/SD: - The SPL and u-boot-dtb.img images need to be flashed into the micro SD card: $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync $ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync - Boot mode settings: Boot switch position: SW1 -> 0 SW2 -> 0 Boot from eMMC: - if bootpart is not enabled by default, to enable under Linux echo 0 >/sys/block/mmcblk1boot0/force_ro mmc bootpart enable 1 1 /dev/mmcblk1boot0 - Flash the SPL and u-boot-dtb.img to mmcblk1boot0 $ sudo dd if=SPL of=/dev/mmcblk1boot0 bs=1k seek=1; sync $ sudo dd if=u-boot-dtb.img of=/dev/mmcblk1boot0 bs=1k seek=69; sync - Boot mode settings: Boot switch position: SW1 -> 0 SW2 -> 1 - Connect the Serial cable to UART0 and the PC for the console. - Insert the micro SD card in the board and power it up. - U-Boot messages should come up.