Bo Shen b899fa3901 arm: at91sam9n12: change EBI IO to high drive mode ... As both the DDR SDRAM and NAND flash connect to EBI on at91sam9n12 and share the lower 8 bits data line. If use low drive of the data line, it will cause DDR data access corrupt in lower address, so change the data line to high drive mode This will fix the Linux kernel boot issue when use Lower address Signed-off-by: Bo Shen <voice.shen@atmel.com> Acked-by: Andreas Bießmann <andreas.devel@googlemail.com>		2013-07-22 08:20:14 -04:00
..
at91rm9200ek	punt unused clean/distclean targets	2011-10-15 22:20:36 +02:00
at91sam9m10g45ek	arm:at91-boards: remove console_init_f where unnecessary	2012-09-01 17:06:14 +02:00
at91sam9n12ek	arm: at91sam9n12: change EBI IO to high drive mode	2013-07-22 08:20:14 -04:00
at91sam9rlek	arm:at91-boards: remove console_init_f where unnecessary	2012-09-01 17:06:14 +02:00
at91sam9x5ek	at91sam9x5: enable USB support for 9x5ek board.	2012-12-09 22:38:27 +01:00
at91sam9260ek	at91sam9260ek: move board id setup to config header	2013-05-12 16:49:14 +02:00
at91sam9261ek	arm:at91-boards: remove console_init_f where unnecessary	2012-09-01 17:06:14 +02:00
at91sam9263ek	at91sam9263ek: remove unnecessary console_init_f	2012-09-01 17:06:14 +02:00
atngw100	atngw100: move CONFIG_SYS_TEXT_BASE to header	2011-05-18 07:56:54 +02:00
atngw100mkii	avr32: add atngw100mkii board	2012-09-13 13:33:11 +02:00
atstk1000	atstk100x: switch to common cfi driver	2011-07-04 10:55:27 +02:00
sama5d3xek	ARM: atmel: add sama5d3xek support	2013-05-21 11:54:16 +02:00