u-boot-brain

History

Yangbo Lu e37ac717d7 Convert to use fsl_esdhc_imx for i.MX platforms Converted to use fsl_esdhc_imx for i.MX platforms. Signed-off-by: Yangbo Lu <yangbo.lu@nxp.com> Tested-by: Steffen Dirkwinkel <s.dirkwinkel@beckhoff.com> Reviewed-by: Peng Fan <peng.fan@nxp.com> Reviewed-by: Lukasz Majewski <lukma@denx.de> Reviewed-by: Martyn Welch <martyn.welch@collabora.com> Acked-by: Jason Liu <Jason.hui.liu@nxp.com>		2019-06-23 14:18:34 +08:00
..
Kconfig	imx: Add variscite DART-6UL Evaluation Kit	2019-04-25 19:16:24 +02:00
MAINTAINERS	imx: Add variscite DART-6UL Evaluation Kit	2019-04-25 19:16:24 +02:00
Makefile	imx: Add variscite DART-6UL Evaluation Kit	2019-04-25 19:16:24 +02:00
README	imx: Add variscite DART-6UL Evaluation Kit	2019-04-25 19:16:24 +02:00
dart_6ul.c	Convert to use fsl_esdhc_imx for i.MX platforms	2019-06-23 14:18:34 +08:00
spl.c	Convert to use fsl_esdhc_imx for i.MX platforms	2019-06-23 14:18:34 +08:00

README

How to use U-Boot on variscite DART-6UL Evaluation Kit
------------------------------------------------------

- Configure and build U-Boot for DART-6UL iMX6ULL:

    $ make mrproper
    $ make variscite_dart6ul_defconfig
    $ make

  This will generate SPL and u-boot-dtb.img images.

Boot from MMC/SD:
- The SPL and u-boot-dtb.img images need to be flashed into the micro SD card:

    $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
    $ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Boot mode settings:

  Boot switch position: SW1 -> 0
			SW2 -> 0

Boot from eMMC:
- if bootpart is not enabled by default, to enable under Linux
	echo 0 >/sys/block/mmcblk1boot0/force_ro
	mmc bootpart enable 1 1 /dev/mmcblk1boot0

- Flash the SPL and u-boot-dtb.img to mmcblk1boot0
    $ sudo dd if=SPL of=/dev/mmcblk1boot0 bs=1k seek=1; sync
    $ sudo dd if=u-boot-dtb.img of=/dev/mmcblk1boot0 bs=1k seek=69; sync

- Boot mode settings:

  Boot switch position: SW1 -> 0
			SW2 -> 1

- Connect the Serial cable to UART0 and the PC for the console.

- Insert the micro SD card in the board and power it up.

- U-Boot messages should come up.