mirror of
https://github.com/brain-hackers/u-boot-brain
synced 2024-08-20 17:08:52 +09:00
![]() Port for the DART-6UL Evaluation Kit SBC. Based on the variscite DART-6UL iMX6ULL SoM. CPU: Freescale i.MX6ULL rev1.1 900 MHz (running at 396 MHz) CPU: Commercial temperature grade (0C to 95C) at 43C Reset cause: POR Model: Variscite DART-6UL Evaluation Kit Board: Variscite DART-6UL Evaluation Kit DRAM: 512 MiB MMC: FSL_SDHC: 0, FSL_SDHC: 1 In: serial@02020000 Out: serial@02020000 Err: serial@02020000 Net: FEC0 Working: - Eth0 - i2c - MMC/SD - eMMC - USB host - UART 1 Note: LCDIF porting needs DM_VIDEO https://lists.denx.de/pipermail/u-boot/2019-April/365506.html Signed-off-by: Parthiban Nallathambi <parthitce@gmail.com> |
||
---|---|---|
.. | ||
dart_6ul.c | ||
Kconfig | ||
MAINTAINERS | ||
Makefile | ||
README | ||
spl.c |
How to use U-Boot on variscite DART-6UL Evaluation Kit ------------------------------------------------------ - Configure and build U-Boot for DART-6UL iMX6ULL: $ make mrproper $ make variscite_dart6ul_defconfig $ make This will generate SPL and u-boot-dtb.img images. Boot from MMC/SD: - The SPL and u-boot-dtb.img images need to be flashed into the micro SD card: $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync $ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync - Boot mode settings: Boot switch position: SW1 -> 0 SW2 -> 0 Boot from eMMC: - if bootpart is not enabled by default, to enable under Linux echo 0 >/sys/block/mmcblk1boot0/force_ro mmc bootpart enable 1 1 /dev/mmcblk1boot0 - Flash the SPL and u-boot-dtb.img to mmcblk1boot0 $ sudo dd if=SPL of=/dev/mmcblk1boot0 bs=1k seek=1; sync $ sudo dd if=u-boot-dtb.img of=/dev/mmcblk1boot0 bs=1k seek=69; sync - Boot mode settings: Boot switch position: SW1 -> 0 SW2 -> 1 - Connect the Serial cable to UART0 and the PC for the console. - Insert the micro SD card in the board and power it up. - U-Boot messages should come up.