mirror of
https://github.com/brain-hackers/u-boot-brain
synced 2024-07-10 21:26:19 +09:00
69cc97f8db
As per OMAP3530 TRM referenced below [1] For large-page NAND, ROM code expects following ecc-layout for HAM1 ecc-scheme - OOB[1] (offset of 1 *byte* from start of OOB) for x8 NAND device - OOB[2] (offset of 1 *word* from start of OOB) for x16 NAND device Thus ecc-layout expected by ROM code for HAM1 ecc-scheme is: *for x8 NAND Device* +--------+---------+---------+---------+---------+---------+---------+ | xxxx | ECC[A0] | ECC[A1] | ECC[A2] | ECC[B0] | ECC[B1] | ECC[B2] | ... +--------+---------+---------+---------+---------+---------+---------+ *for x16 NAND Device* +--------+--------+---------+---------+---------+---------+---------+---------+ | xxxxx | xxxxx | ECC[A0] | ECC[A1] | ECC[A2] | ECC[B0] | ECC[B1] | ECC[B2] | +--------+--------+---------+---------+---------+---------+---------+---------+ This patch fixes ecc-layout *only* for HAM1, as required by ROM-code For other ecc-schemes like (BCH8) ecc-layout is same for x8 or x16 devices. [1] OMAP3530: http://www.ti.com/product/omap3530 TRM: http://www.ti.com/litv/pdf/spruf98x Chapter-25: Initialization Sub-topic: Memory Booting Section: 25.4.7.4 NAND Figure 25-19. ECC Locations in NAND Spare Areas Reported-by: Stefan Roese <sr@denx.de> Signed-off-by: Pekon Gupta <pekon@ti.com> Tested-by: Stefan Roese <sr@denx.de> |
||
---|---|---|
.. | ||
nand | ||
onenand | ||
spi | ||
ubi | ||
at45.c | ||
cfi_flash.c | ||
cfi_mtd.c | ||
dataflash.c | ||
ftsmc020.c | ||
jedec_flash.c | ||
Makefile | ||
mtdconcat.c | ||
mtdcore.c | ||
mtdpart.c | ||
mw_eeprom.c | ||
st_smi.c |