mirror of
https://github.com/brain-hackers/u-boot-brain
synced 2024-06-09 23:36:03 +09:00
401d1c4f5d
Move this out of the common header and include it only where needed. In a number of cases this requires adding "struct udevice;" to avoid adding another large header or in other cases replacing / adding missing header files that had been pulled in, very indirectly. Finally, we have a few cases where we did not need to include <asm/global_data.h> at all, so remove that include. Signed-off-by: Simon Glass <sjg@chromium.org> Signed-off-by: Tom Rini <trini@konsulko.com> |
||
|---|---|---|
| .. | ||
| imximage.cfg | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| README | ||
| warp.c | ||
How to Update U-Boot on Warp board ---------------------------------- Required software on the host PC: - imx_usb_loader: https://github.com/boundarydevices/imx_usb_loader - dfu-util: http://dfu-util.sourceforge.net/releases/ Build U-Boot for Warp: $ make mrproper $ make warp_config $ make This will generate the U-Boot binary called u-boot.imx. Put warp board in USB download mode Connect a USB to serial adapter between the host PC and warp Connect a USB cable between the OTG warp port and the host PC Open a terminal program such as minicom Copy u-boot.imx to the imx_usb_loader folder. Load u-boot.imx via USB: $ sudo ./imx_usb u-boot.imx Then U-Boot should start and its messages will appear in the console program. Use the default environment variables: => env default -f -a => saveenv Run the DFU command: => dfu 0 mmc 0 Transfer u-boot.imx that will be flashed into the eMMC: $ sudo dfu-util -D u-boot.imx -a boot Then on the U-Boot prompt the following message should be seen after a successful upgrade: #DOWNLOAD ... OK Ctrl+C to exit ... Remove power from the warp board. Put warp board into normal boot mode Power up the board and the new updated U-Boot should boot from eMMC