mirror of
https://github.com/brain-hackers/u-boot-brain
synced 2024-06-09 23:36:03 +09:00
401d1c4f5d
Move this out of the common header and include it only where needed. In a number of cases this requires adding "struct udevice;" to avoid adding another large header or in other cases replacing / adding missing header files that had been pulled in, very indirectly. Finally, we have a few cases where we did not need to include <asm/global_data.h> at all, so remove that include. Signed-off-by: Simon Glass <sjg@chromium.org> Signed-off-by: Tom Rini <trini@konsulko.com> |
||
|---|---|---|
| .. | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| README | ||
| spl.c | ||
| wandboard.c | ||
U-Boot for Wandboard -------------------- This file contains information for the port of U-Boot to the Wandboard. Wandboard is a development board that has three variants based on the following SoCs: mx6 quad, mx6 quad plus, mx6 dual lite and mx6 solo. For more details about Wandboard, please refer to: http://www.wandboard.org/ Building U-Boot for Wandboard ----------------------------- To build U-Boot for the Wandboard: $ make wandboard_config $ make Flashing U-Boot into the SD card -------------------------------- - After the 'make' command completes, the generated 'SPL' binary must be flashed into the SD card; $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync (Note - the SD card node may vary, so adjust this as needed). - Flash the u-boot.img image into the SD card: sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync - Insert the SD card into the slot located in the bottom of the board (same side as the mx6 processor) - Connect the serial cable to the host PC - Power up the board and U-Boot messages will appear in the serial console. Debug UART ---------- The following settings provide a debug UART for the Wandboard: CONFIG_DEBUG_UART=y CONFIG_DEBUG_UART_MXC=y CONFIG_DEBUG_UART_BASE=0x02020000 CONFIG_DEBUG_UART_CLOCK=80000000