mirror of
https://github.com/brain-hackers/u-boot-brain
synced 2024-08-21 01:18:52 +09:00
![Giulio Benetti](/assets/img/avatar_default.png)
This commit adds board support for i.MXRT1050-EVK from NXP. This board is an evaluation kit provided by NXP for i.MXRT105x processor family. More information about this board can be found here: https://www.nxp.com/design/development-boards/i.mx-evaluation-and-development-boards/i.mx-rt1050-evaluation-kit:MIMXRT1050-EVK The initial supported/tested devices include: - Debug serial - SD Signed-off-by: Giulio Benetti <giulio.benetti@benettiengineering.com>
32 lines
812 B
Plaintext
32 lines
812 B
Plaintext
How to use U-Boot on NXP i.MXRT1050 EVK
|
|
-----------------------------------------------
|
|
|
|
- Build U-Boot for i.MXRT1050 EVK:
|
|
|
|
$ make mrproper
|
|
$ make imxrt1050-evk_defconfig
|
|
$ make
|
|
|
|
This will generate the SPL image called SPL and the u-boot.img.
|
|
|
|
- Flash the SPL image into the micro SD card:
|
|
|
|
sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
|
|
|
|
- Flash the u-boot.img image into the micro SD card:
|
|
|
|
sudo dd if=u-boot.img of=/dev/sdb bs=1k seek=128; sync
|
|
|
|
- Jumper settings:
|
|
|
|
SW7: 1 0 1 0
|
|
|
|
where 0 means bottom position and 1 means top position (from the
|
|
switch label numbers reference).
|
|
|
|
- Connect the USB cable between the EVK and the PC for the console.
|
|
(The USB console connector is the one close the ethernet connector)
|
|
|
|
- Insert the micro SD card in the board, power it up and U-Boot messages should
|
|
come up.
|