u-boot-brain/drivers/sysreset/Kconfig
Michal Simek 0d832b3221 sysreset: Add support for gpio-restart
The Linux kernel has binding for gpio-restart node.
This patch is adding basic support without supporting any optional
properties.
This driver was tested on Microblaze system where gpio is connected to
SoC reset logic.
Output value is handled via gpios cells values.

In gpio_reboot_request() set_value is writing 1 because
dm_gpio_set_value() is capable to changing it when it is ACTIVE_LOW.
...
	if (desc->flags & GPIOD_ACTIVE_LOW)
		value = !value;
...

Signed-off-by: Michal Simek <michal.simek@xilinx.com>
Reviewed-by: Philipp Tomsich <philipp.tomsich@theobroma-systems.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
2018-07-19 10:49:55 +02:00

49 lines
1.2 KiB
Plaintext

#
# System reset devices
#
menu "System reset device drivers"
config SYSRESET
bool "Enable support for system reset drivers"
depends on DM
help
Enable system reset drivers which can be used to reset the CPU or
board. Each driver can provide a reset method which will be called
to effect a reset. The uclass will try all available drivers when
reset_walk() is called.
if SYSRESET
config SYSRESET_GPIO
bool "Enable support for GPIO reset driver"
select GPIO
help
Reset support via GPIO pin connected reset logic. This is used for
example on Microblaze where reset logic can be controlled via GPIO
pin which triggers cpu reset.
config SYSRESET_PSCI
bool "Enable support for PSCI System Reset"
depends on ARM_PSCI_FW
help
Enable PSCI SYSTEM_RESET function call. To use this, PSCI firmware
must be running on your system.
endif
config SYSRESET_SYSCON
bool "Enable support for mfd syscon reboot driver"
select REGMAP
select SYSCON
help
Reboot support for generic SYSCON mapped register reset.
config SYSRESET_WATCHDOG
bool "Enable support for watchdog reboot driver"
select WDT
help
Reboot support for generic watchdog reset.
endmenu