56 lines
1.3 KiB
Plaintext
56 lines
1.3 KiB
Plaintext
Intel Apollo Lake GPIO controller
|
|
|
|
The Apollo Lake (APL) GPIO controller is used to control GPIO functions of
|
|
the pins.
|
|
|
|
Required properties:
|
|
- compatible: "intel,apl-gpio"
|
|
- #gpio-cells: Should be 2. The syntax of the gpio specifier used by client
|
|
nodes should be the following with values derived from the SoC user manual.
|
|
<[phandle of the gpio controller node]
|
|
[pin number within the gpio controller]
|
|
[flags]>
|
|
|
|
Values for gpio specifier:
|
|
- Pin number: is a GPIO pin number between 0 and 244
|
|
- Flags: GPIO_ACTIVE_HIGH or GPIO_ACTIVE_LOW
|
|
|
|
- gpio-controller: Specifies that the node is a gpio controller.
|
|
|
|
Example:
|
|
|
|
...
|
|
{
|
|
p2sb: p2sb@d,0 {
|
|
reg = <0x02006810 0 0 0 0>;
|
|
compatible = "intel,p2sb";
|
|
early-regs = <IOMAP_P2SB_BAR 0x100000>;
|
|
|
|
north {
|
|
compatible = "intel,apl-pinctrl";
|
|
intel,p2sb-port-id = <PID_GPIO_N>;
|
|
gpio_n: gpio-n {
|
|
compatible = "intel,gpio";
|
|
gpio-controller;
|
|
#gpio-cells = <2>;
|
|
};
|
|
};
|
|
};
|
|
|
|
i2c_2: i2c2@16,2 {
|
|
compatible = "intel,apl-i2c", "snps,designware-i2c-pci";
|
|
reg = <0x0200b210 0 0 0 0>;
|
|
#address-cells = <1>;
|
|
#size-cells = <0>;
|
|
clock-frequency = <400000>;
|
|
tpm@50 {
|
|
reg = <0x50>;
|
|
compatible = "google,cr50";
|
|
u-boot,i2c-offset-len = <0>;
|
|
ready-gpios = <&gpio_n GPIO_28 GPIO_ACTIVE_LOW>;
|
|
};
|
|
};
|
|
|
|
};
|
|
...
|