u-boot-brain/board/sipeed/maix/Kconfig
Sean Anderson 8f78e52794 riscv: Add support for SPI on Kendryte K210
This enables configs necessary for using SPI. The environment is saved to
the very end of SPI flash. This is unlikely to be overwritten unless the
entire flash is reprogrammed.

This also supplies a default bootcommand. It loads an image and device tree
from the first partition of the MMC. This is a minimal/least effort
bootcmd, so suggestions (especially in the form of patches) are welcome. I
didn't set up distro boot because I think it is unlikely that any
general-purpose linux distros will ever be ported to this board.

Signed-off-by: Sean Anderson <seanga2@gmail.com>
Tested-by: Chrstopher Obbard <obbardc@gmail.com>
Reviewed-by: Rick Chen <rick@andestech.com>
2021-01-18 11:06:26 +08:00

73 lines
1.2 KiB
Plaintext

# SPDX-License-Identifier: GPL-2.0+
# Copyright (C) 2019-20 Sean Anderson <seanga2@gmail.com>
if TARGET_SIPEED_MAIX
config SYS_BOARD
default "maix"
config SYS_VENDOR
default "sipeed"
config SYS_CPU
default "generic"
config SYS_CONFIG_NAME
default "sipeed-maix"
config SYS_TEXT_BASE
default 0x80000000
config DEFAULT_DEVICE_TREE
default "k210-maix-bit"
config NR_CPUS
default 2
config NR_DRAM_BANKS
default 3
config BOARD_SPECIFIC_OPTIONS
def_bool y
select GENERIC_RISCV
select RISCV_PRIV_1_9
imply SMP
imply DM_SERIAL
imply SIFIVE_SERIAL
imply SIFIVE_CLINT
imply POWER_DOMAIN
imply SIMPLE_PM_BUS
imply CLK_CCF
imply CLK_COMPOSITE_CCF
imply CLK_K210
imply DM_RESET
imply RESET_SYSCON
imply SYSRESET
imply SYSRESET_SYSCON
imply PINCTRL
imply PINCONF
imply PINCTRL_K210
imply DM_GPIO
imply DWAPB_GPIO
imply SIFIVE_GPIO
imply CMD_GPIO
imply LED
imply LED_GPIO
imply SPI
imply DESIGNWARE_SPI
imply SPI_FLASH_GIGADEVICE
imply SPI_FLASH_WINBOND
imply DM_MTD
imply SPI_FLASH_MTD
imply CMD_MTD
imply ENV_IS_IN_SPI_FLASH
imply MMC
imply MMC_BROKEN_CD
imply MMC_SPI
imply CMD_MMC
imply DOS_PARTITION
imply EFI_PARTITION
imply CMD_PART
imply CMD_FS_GENERIC
endif