mirror of
https://github.com/brain-hackers/u-boot-brain
synced 2024-09-30 16:40:44 +09:00
pxa27x_udc: remove call to unimplemented set_GPIO_mode()
If CONFIG_USB_DEV_PULLUP_GPIO is defined, a link error occurs because the set_GPIO_mode() helper function is not implemented. This function doesn't do much except make the code a little more readable, so I just manually coded its equivalent and removed the prototype from the header file. It is invoked no where else in the code. While I was at it, I noticed that two other function prototypes in the same header file are also neither implemented nor invoked anywhere, so I removed them as well. Signed-off-by: Mike Dunn <mikedunn@newsguy.com>
This commit is contained in:
parent
86e929e825
commit
e0e89e236f
@ -77,17 +77,6 @@
|
|||||||
#define GPIO_FALLING_EDGE 1
|
#define GPIO_FALLING_EDGE 1
|
||||||
#define GPIO_RISING_EDGE 2
|
#define GPIO_RISING_EDGE 2
|
||||||
#define GPIO_BOTH_EDGES 3
|
#define GPIO_BOTH_EDGES 3
|
||||||
extern void set_GPIO_IRQ_edge( int gpio_nr, int edge_mask );
|
|
||||||
|
|
||||||
/*
|
|
||||||
* Handy routine to set GPIO alternate functions
|
|
||||||
*/
|
|
||||||
extern void set_GPIO_mode( int gpio_mode );
|
|
||||||
|
|
||||||
/*
|
|
||||||
* return current lclk frequency in units of 10kHz
|
|
||||||
*/
|
|
||||||
extern unsigned int get_lclk_frequency_10khz(void);
|
|
||||||
|
|
||||||
#endif
|
#endif
|
||||||
|
|
||||||
|
@ -610,7 +610,9 @@ void udc_connect(void)
|
|||||||
|
|
||||||
#ifdef CONFIG_USB_DEV_PULLUP_GPIO
|
#ifdef CONFIG_USB_DEV_PULLUP_GPIO
|
||||||
/* Turn on the USB connection by enabling the pullup resistor */
|
/* Turn on the USB connection by enabling the pullup resistor */
|
||||||
set_GPIO_mode(CONFIG_USB_DEV_PULLUP_GPIO | GPIO_OUT);
|
writel(readl(GPDR(CONFIG_USB_DEV_PULLUP_GPIO))
|
||||||
|
| GPIO_bit(CONFIG_USB_DEV_PULLUP_GPIO),
|
||||||
|
GPDR(CONFIG_USB_DEV_PULLUP_GPIO));
|
||||||
writel(GPIO_bit(CONFIG_USB_DEV_PULLUP_GPIO), GPSR(CONFIG_USB_DEV_PULLUP_GPIO));
|
writel(GPIO_bit(CONFIG_USB_DEV_PULLUP_GPIO), GPSR(CONFIG_USB_DEV_PULLUP_GPIO));
|
||||||
#else
|
#else
|
||||||
/* Host port 2 transceiver D+ pull up enable */
|
/* Host port 2 transceiver D+ pull up enable */
|
||||||
|
Loading…
Reference in New Issue
Block a user