ARM: uniphier: use gd->bd->bi_dram for memory reserve on LD20 SoC

For LD20 SoC, the last 64 byte of each DRAM bank is used for the
dynamic training of DRAM PHY.  The regions must be reserved in DT to
prevent the kernel from using them.  Now gd->bd->bi_dram reflects
the actual memory banks.  Just use it instead of getting access to
the board parameters.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
This commit is contained in:
Masahiro Yamada 2017-01-28 06:53:44 +09:00
parent 3e9952be23
commit c995f3a3c5

View File

@ -248,22 +248,15 @@ void dram_init_banksize(void)
*/
int ft_board_setup(void *fdt, bd_t *bd)
{
const struct uniphier_board_data *param;
unsigned long rsv_addr;
const unsigned long rsv_size = 64;
int ch, ret;
int i, ret;
if (uniphier_get_soc_id() != UNIPHIER_LD20_ID)
return 0;
param = uniphier_get_board_param();
if (!param) {
printf("failed to get board parameter\n");
return -ENODEV;
}
for (ch = 0; ch < param->dram_nr_ch; ch++) {
rsv_addr = param->dram_ch[ch].base + param->dram_ch[ch].size;
for (i = 0; i < ARRAY_SIZE(gd->bd->bi_dram); i++) {
rsv_addr = gd->bd->bi_dram[i].start + gd->bd->bi_dram[i].size;
rsv_addr -= rsv_size;
ret = fdt_add_mem_rsv(fdt, rsv_addr, rsv_size);