Blackfin: add support for fast SPI reads with Boot ROM

Newer Blackfin boot roms support using the fast SPI read command rather than
just the slow one.  If the functionality is available, then use it.

Signed-off-by: Mike Frysinger <vapier@gentoo.org>
This commit is contained in:
Mike Frysinger 2008-12-09 17:21:08 -05:00
parent 67619982bf
commit 97f265f14f

View File

@ -133,12 +133,22 @@ static inline void serial_putc(char c)
}
/* Max SCLK can be 133MHz ... dividing that by 4 gives
* us a freq of 33MHz for SPI which should generally be
/* Max SCLK can be 133MHz ... dividing that by (2*4) gives
* us a freq of 16MHz for SPI which should generally be
* slow enough for the slow reads the bootrom uses.
*/
#if !defined(CONFIG_SPI_FLASH_SLOW_READ) && \
((defined(__ADSPBF52x__) && __SILICON_REVISION__ >= 2) || \
(defined(__ADSPBF54x__) && __SILICON_REVISION__ >= 1))
# define BOOTROM_SUPPORTS_SPI_FAST_READ 1
#else
# define BOOTROM_SUPPORTS_SPI_FAST_READ 0
#endif
#ifndef CONFIG_SPI_BAUD_INITBLOCK
# define CONFIG_SPI_BAUD_INITBLOCK 4
# define CONFIG_SPI_BAUD_INITBLOCK (BOOTROM_SUPPORTS_SPI_FAST_READ ? 2 : 4)
#endif
#ifdef SPI0_BAUD
# define bfin_write_SPI_BAUD bfin_write_SPI0_BAUD
#endif
/* PLL_DIV defines */
@ -254,12 +264,11 @@ void initcode(ADI_BOOT_DATA *bootstruct)
* boot. Once we switch over to u-boot's SPI flash driver, we'll
* increase the speed appropriately.
*/
if (CONFIG_BFIN_BOOT_MODE == BFIN_BOOT_SPI_MASTER)
#ifdef SPI0_BAUD
bfin_write_SPI0_BAUD(CONFIG_SPI_BAUD_INITBLOCK);
#else
if (CONFIG_BFIN_BOOT_MODE == BFIN_BOOT_SPI_MASTER) {
if (BOOTROM_SUPPORTS_SPI_FAST_READ && CONFIG_SPI_BAUD_INITBLOCK < 4)
bootstruct->dFlags |= BFLAG_FASTREAD;
bfin_write_SPI_BAUD(CONFIG_SPI_BAUD_INITBLOCK);
#endif
}
serial_putc('B');