mirror of
https://github.com/brain-hackers/u-boot-brain
synced 2024-09-10 23:03:29 +09:00
40 lines
1.2 KiB
Plaintext
40 lines
1.2 KiB
Plaintext
![]() |
STM32 QSPI controller device tree bindings
|
||
|
--------------------------------------------
|
||
|
|
||
|
Required properties:
|
||
|
- compatible : should be "st,stm32-qspi".
|
||
|
- reg : 1. Physical base address and size of SPI registers map.
|
||
|
2. Physical base address & size of mapped NOR Flash.
|
||
|
- spi-max-frequency : Max supported spi frequency.
|
||
|
- status : enable in requried dts.
|
||
|
|
||
|
Connected flash properties
|
||
|
--------------------------
|
||
|
- spi-max-frequency : Max supported spi frequency.
|
||
|
- spi-tx-bus-width : Bus width (number of lines) for writing (1-4)
|
||
|
- spi-rx-bus-width : Bus width (number of lines) for reading (1-4)
|
||
|
- memory-map : Address and size for memory-mapping the flash
|
||
|
|
||
|
Example:
|
||
|
qspi: quadspi@A0001000 {
|
||
|
compatible = "st,stm32-qspi";
|
||
|
#address-cells = <1>;
|
||
|
#size-cells = <0>;
|
||
|
reg = <0xA0001000 0x1000>, <0x90000000 0x10000000>;
|
||
|
reg-names = "QuadSPI", "QuadSPI-memory";
|
||
|
interrupts = <92>;
|
||
|
spi-max-frequency = <108000000>;
|
||
|
status = "okay";
|
||
|
|
||
|
qflash0: n25q128a {
|
||
|
#address-cells = <1>;
|
||
|
#size-cells = <1>;
|
||
|
compatible = "micron,n25q128a13", "spi-flash";
|
||
|
spi-max-frequency = <108000000>;
|
||
|
spi-tx-bus-width = <4>;
|
||
|
spi-rx-bus-width = <4>;
|
||
|
memory-map = <0x90000000 0x1000000>;
|
||
|
reg = <0>;
|
||
|
};
|
||
|
};
|