Merge branch 'spi-5.3' into spi-linus

This commit is contained in:
Mark Brown 2019-09-15 10:32:04 +01:00
commit 262a2f3345
No known key found for this signature in database
GPG Key ID: 24D68B725D5487D0
7 changed files with 34 additions and 7 deletions

View File

@ -31,7 +31,7 @@ properties:
If that property is used, the number of chip selects will be
increased automatically with max(cs-gpios, hardware chip selects).
So if, for example, the controller has 2 CS lines, and the
So if, for example, the controller has 4 CS lines, and the
cs-gpios looks like this
cs-gpios = <&gpio1 0 0>, <0>, <&gpio1 1 0>, <&gpio1 2 0>;

View File

@ -343,7 +343,7 @@ static int bcm_qspi_bspi_set_flex_mode(struct bcm_qspi *qspi,
{
int bpc = 0, bpp = 0;
u8 command = op->cmd.opcode;
int width = op->cmd.buswidth ? op->cmd.buswidth : SPI_NBITS_SINGLE;
int width = op->data.buswidth ? op->data.buswidth : SPI_NBITS_SINGLE;
int addrlen = op->addr.nbytes;
int flex_mode = 1;
@ -981,7 +981,7 @@ static int bcm_qspi_exec_mem_op(struct spi_mem *mem,
if (mspi_read)
return bcm_qspi_mspi_exec_mem_op(spi, op);
ret = bcm_qspi_bspi_set_mode(qspi, op, -1);
ret = bcm_qspi_bspi_set_mode(qspi, op, 0);
if (!ret)
ret = bcm_qspi_bspi_exec_mem_op(spi, op);

View File

@ -319,6 +319,13 @@ static void bcm2835_spi_reset_hw(struct spi_controller *ctlr)
BCM2835_SPI_CS_INTD |
BCM2835_SPI_CS_DMAEN |
BCM2835_SPI_CS_TA);
/*
* Transmission sometimes breaks unless the DONE bit is written at the
* end of every transfer. The spec says it's a RO bit. Either the
* spec is wrong and the bit is actually of type RW1C, or it's a
* hardware erratum.
*/
cs |= BCM2835_SPI_CS_DONE;
/* and reset RX/TX FIFOS */
cs |= BCM2835_SPI_CS_CLEAR_RX | BCM2835_SPI_CS_CLEAR_TX;
@ -477,7 +484,9 @@ static void bcm2835_spi_transfer_prologue(struct spi_controller *ctlr,
bcm2835_wr_fifo_count(bs, bs->rx_prologue);
bcm2835_wait_tx_fifo_empty(bs);
bcm2835_rd_fifo_count(bs, bs->rx_prologue);
bcm2835_spi_reset_hw(ctlr);
bcm2835_wr(bs, BCM2835_SPI_CS, cs | BCM2835_SPI_CS_CLEAR_RX
| BCM2835_SPI_CS_CLEAR_TX
| BCM2835_SPI_CS_DONE);
dma_sync_single_for_device(ctlr->dma_rx->device->dev,
sg_dma_address(&tfr->rx_sg.sgl[0]),
@ -498,7 +507,8 @@ static void bcm2835_spi_transfer_prologue(struct spi_controller *ctlr,
| BCM2835_SPI_CS_DMAEN);
bcm2835_wr_fifo_count(bs, tx_remaining);
bcm2835_wait_tx_fifo_empty(bs);
bcm2835_wr(bs, BCM2835_SPI_CS, cs | BCM2835_SPI_CS_CLEAR_TX);
bcm2835_wr(bs, BCM2835_SPI_CS, cs | BCM2835_SPI_CS_CLEAR_TX
| BCM2835_SPI_CS_DONE);
}
if (likely(!bs->tx_spillover)) {

View File

@ -19,6 +19,7 @@ struct spi_pci_desc {
int (*setup)(struct dw_spi *);
u16 num_cs;
u16 bus_num;
u32 max_freq;
};
static struct spi_pci_desc spi_pci_mid_desc_1 = {
@ -33,6 +34,12 @@ static struct spi_pci_desc spi_pci_mid_desc_2 = {
.bus_num = 1,
};
static struct spi_pci_desc spi_pci_ehl_desc = {
.num_cs = 1,
.bus_num = -1,
.max_freq = 100000000,
};
static int spi_pci_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
{
struct dw_spi *dws;
@ -65,6 +72,7 @@ static int spi_pci_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
if (desc) {
dws->num_cs = desc->num_cs;
dws->bus_num = desc->bus_num;
dws->max_freq = desc->max_freq;
if (desc->setup) {
ret = desc->setup(dws);
@ -125,8 +133,14 @@ static const struct pci_device_id pci_ids[] = {
{ PCI_VDEVICE(INTEL, 0x0800), (kernel_ulong_t)&spi_pci_mid_desc_1},
/* Intel MID platform SPI controller 2 */
{ PCI_VDEVICE(INTEL, 0x0812), (kernel_ulong_t)&spi_pci_mid_desc_2},
/* Intel Elkhart Lake PSE SPI controllers */
{ PCI_VDEVICE(INTEL, 0x4b84), (kernel_ulong_t)&spi_pci_ehl_desc},
{ PCI_VDEVICE(INTEL, 0x4b85), (kernel_ulong_t)&spi_pci_ehl_desc},
{ PCI_VDEVICE(INTEL, 0x4b86), (kernel_ulong_t)&spi_pci_ehl_desc},
{ PCI_VDEVICE(INTEL, 0x4b87), (kernel_ulong_t)&spi_pci_ehl_desc},
{},
};
MODULE_DEVICE_TABLE(pci, pci_ids);
static struct pci_driver dw_spi_driver = {
.name = DRIVER_NAME,

View File

@ -886,9 +886,11 @@ static irqreturn_t dspi_interrupt(int irq, void *dev_id)
trans_mode);
}
}
return IRQ_HANDLED;
}
return IRQ_HANDLED;
return IRQ_NONE;
}
static const struct of_device_id fsl_dspi_dt_ids[] = {

View File

@ -214,6 +214,7 @@ static void uniphier_spi_setup_transfer(struct spi_device *spi,
if (!priv->is_save_param || priv->mode != spi->mode) {
uniphier_spi_set_mode(spi);
priv->mode = spi->mode;
priv->is_save_param = false;
}
if (!priv->is_save_param || priv->bits_per_word != t->bits_per_word) {

View File

@ -695,7 +695,7 @@ static int zynq_qspi_probe(struct platform_device *pdev)
ctlr->setup = zynq_qspi_setup_op;
ctlr->max_speed_hz = clk_get_rate(xqspi->refclk) / 2;
ctlr->dev.of_node = np;
ret = spi_register_controller(ctlr);
ret = devm_spi_register_controller(&pdev->dev, ctlr);
if (ret) {
dev_err(&pdev->dev, "spi_register_master failed\n");
goto clk_dis_all;